Virgin Mary Statue Repair
This project came from Ascension Catholic Church in Kettering, Ohio, which asked me to repair a cherished hand-carved statue. As you can see, several fingers had broken off and needed to be reattached. Fortunately, all of the original pieces had been saved, and the breaks were clean.
Before working on the actual statue, I carved and intentionally broke several practice pieces to test different repair methods. After a number of unsuccessful trials, I selected a fast-setting CA (cyanoacrylate) adhesive that provided the best combination of strength and precision.
The first step was to seal the exposed wood fibers with a thin application of CA glue, allowing it to fully cure for a week. The most stressful phase followed: reattaching the fingers. Using a thin CA adhesive with a working time of only about 15 seconds, I carefully aligned each piece and maintained hand pressure for approximately 45 seconds to ensure a secure bond. The repairs were then left undisturbed for another week.
Once the adhesive had fully cured, I filled and blended the repair areas with wood putty and stain to integrate the new work with the original wood. A two-part carver’s epoxy was then applied along the seams to reinforce the repairs and eliminate any visible gaps. After curing, the hands were lightly sanded, sealed, and carefully color-matched with custom-mixed paints to replicate the original tones and finish.
This was a particularly demanding restoration because of the statue’s significance to the parish community. The piece was hand-crafted in South America specifically for the church and holds deep meaning for its members. The successful restoration preserved both the artwork and its history, and the statue is once again on display in the church school.



